• Welcome to Ecoboost Performance Forum. Please log in or sign up.
collapse

P0455 Code

Started by FaSSt9602, June 04, 2014, 07:37:24 PM

Previous topic - Next topic

FaSSt9602

Anyone gotten one of these on an EB car, possibly Flex specifically?  I know usually the biggest culprit of this code is a bad gas cap, but since the car doesn't have a gas cap, what else should I look for?
2010 EB Flex Limited Dark Ink Blue Metallic/White Suede two tone

Sadly it is the wife's car, so I can't go too crazy on it...just a simple tune for now.

crash712us

My research says it's a purge valve short.


Sent from my iPhone using Tapatalk

2011 tuxedo black non pp, LMS stage 5, Corsa cat back, LMS down pipes, Airaid, Alky control meth injection, Megan Racing coil overs, EBC rotor&pads, Mobsteel grill, 2013 trans cooler. 403whp 417wtq 12.25 @ 110

Courier6

From

http://www.obd-codes.com/p0455

•A loose or improperly affixed gas cap
•A non-conforming gas cap (i.e. not factory/original brand)
•Other leak or damaged piece in EVAP system
2013 Tri-White PP, PPE downpipes, Corsa, Air Raid CAI, H&R Springs, 170 deg thermo, Livernois Dyno Tune 365 AWHP 407 AWTQ. Best 1/4 mile 12.580

ZSHO

The other member is possibly correct,it could be the purge valve,one in the engine and one in the rear,the one in the engine is really cheap,i would personally focus in the gas lid,cause if not sealed properly,due to suction and vapor escaping it will set a code off,check gasket in gas lid,for wear and on the sho they sell a key gas cap,hope this helps


2013 Performance Package SHO| Livernois Custom Methanol Tune|3-Bar Map|Reische-170-Stat|Full Race Tial-10psi BOV in Black|PPE-Gloss Black Hot Pipes|EPP Dual Intake in Gloss Black|PPE Catted DP|Corsa Sport Cat Back Exhaust|H&R Sport-Springs|CFM Performance Billet Valve Cover Breather In Gloss Black|Llumar 20%Ceramic window Tint|MSD Ignition Coils in Black|Extreme Roof Spoiler|Redline Fluids all around|Gearhead Intercooler|First-SHO With Direct Port Alky-VP-M1-100%-Methanol Injection|LMS-Custom-Dyno-Tuned @ 415whp-465wtq| Best Trap Speed of 115.54 mph|

IHeartGroceries

EVAP systems can be headaches, seeing as the systems are designed detect leaks as small as pin holes. Could be a purge valve which is stuck open, or gunked up. Could be a purge valve solenoid which has failed to operate correctly, could be the gas cap. Doubtful there is a leak elsewhere, as most other parts of the system typically have enough integrity to last a decade or so, before cracks and such begin to develop.

Sent from my SM-N900V using Tapatalk

2013 SHO PP