So I finally got a chance to check the new Torque formula and it seem to match Forscan +/- a couple of degrees. I tested it at 150 and 200 and it was very close both times so this new formula seems more accurate. I honestly didn't test it at startup which was a miss on my part because I would like to know if it is off down low or not. The good news is that this one seems to be accurate where it matters...at the upper end of the range...at least compared with Forscan. The only way to really know I guess would be to compare it to an actual gauge and temp sensor. I am going to update the original post as well to hopefully avoid confusion.