OK, so, I finally got everything in and hopefully this helps someone else out...
The adapter that works for the 2013+ master cylinder is the CTA Tools 7040 adapter.
So to sum it up...
To make this work you need the following:
CTA Tools 7040 master cylinder adapter
And you need the 1/8" npt fitting for whichever pressure bleeder you are going to use, in my case I bought an ARES 70921 pressure bleeder, so I need the nipple that will fit and for that I just bought the cheapest master cylinder adapter I could find of theirs which is:
ARES 18054 master cylinder adapter
Then it is just a matter of using a pair of snap ring pliers, taking the snap rings off both adapters, using a pair of needle-nose pliers to hold the area where the snap-rings sit (since the rest goes into the master clinder and you do NOT want to mess it up), hold them firmly and use a wrench or socket to remove the 1/8" npt adapter off each and put the one for your pressure bleeder on the CTA Tools 7040 adapter.
Be sure to keep the o-ring in place and don't over-torque the npt fitting in place since you run the risk of ripping the o-ring and since it is a pressurized system it WILL leak from that location if you rip it.
I am all set to do pressure bleeding tomorrow which will hopefully allow me to finish the damn brake job.