September 21, 2017, 05:20:30 AM
collapse
collapse
Welcome to the Ecoboost Performance Forum
bpd1151
July 05, 2013, 10:24:08 AM by bpd1151
Views: 15509 | Comments: 1

Well, I finally got around to gutting open the outside mirror "puddle lamps" so that I could remove the stock bulb and replace it with a much brighter, LED upgrade.

I've seen lots of posts over the last few months of people asking how to install them, what's involved, questions about bulb sizes, etc.... but I never saw any actual "how-to" write ups on performing this change.

As I've tried to do with all of my mods, both on the SHO, and on my previous Charger build, I will a...
bpd1151
July 05, 2013, 11:05:45 AM by bpd1151
Views: 15707 | Comments: 1

The following step-by-step "How-To" details the measurements I came up with to re-position the TAURUS trunk badge lettering.

I opted to perform this mod because I thought that the final outcome was more much complimentary to the SHO's overly large rear end.

You should compile the following tools to assist you in completing this project:

1 Grease "Stabilo" Type Pencil
1 X-acto knife / razor
1 Measuring Tape
1 Roll of Blue Pa
...
bpd1151
July 05, 2013, 11:24:57 AM by bpd1151
Views: 8755 | Comments: 0

**** Below is a "How-To" Tutorial on removing the old, 2010-2012 style side fender badging that has the verbiage 'TAURUS' molded into them, and instead, upgrading to the newer, 2013+ fender badging that has the 'SHO' verbiage.

This write up, as it appears below, was originally posted in another community, of which I am also a staff member of.

The user name for this creator is/was: "Unknown_Driver".

Therefore, thanks a
...
bpd1151
July 05, 2013, 10:38:15 AM by bpd1151
Views: 10492 | Comments: 3

Below are the steps I took to convert over my entire interior from the standard, factory installed incandescent type bulbs, over to LED's.

It is important to note, that this mod was performed on my 2010 SHO, and others have since found out, there are, or may be, variations in the lamp housing assemblies, depending on model year owned, and/or what option pkg's were ordered.

Although generally speaking, the procedures are very similar, if not the ...
bpd1151
July 05, 2013, 12:36:51 PM by bpd1151
Views: 5841 | Comments: 3

****Below is the info/install steps used to install aftermarket downpipes on your 3.5L V6 Eco Motor.....

This post originally appeared in another community of which I am also a staff member of.

All thanks goes out to the creator, who's user name there was: jdeprato****


Moving along, here is the info as it originally appeared:



Items Needed/Pre-install check...
Pages: 1 2 [3] 4 5 6
 
 
Welcome, Guest. Please login or register.
Did you miss your activation email?

* Top Topics


Back to top