April 21, 2018, 07:54:09 PM
Welcome to the Ecoboost Performance Forum
July 05, 2013, 09:59:58 AM by bpd1151
Views: 56505 | Comments: 2

Here is some info I dug up from various resources, on properly retraining your TPMS Sensors.

Part of this was inspired by the fact that I was forced to purchase new TPMS sensors for my after market TSW wheels.

My Manager pal (Nick Madsen) who works @ NTB (in Downers Grove, IL) was not able to retrain the new sensors as the tool they had was not compatible with Ford.

So off to the Dealership I went.

The tech performing the resets was a newer kid, who al...
July 05, 2013, 10:24:08 AM by bpd1151
Views: 17646 | Comments: 2

Well, I finally got around to gutting open the outside mirror "puddle lamps" so that I could remove the stock bulb and replace it with a much brighter, LED upgrade.

I've seen lots of posts over the last few months of people asking how to install them, what's involved, questions about bulb sizes, etc.... but I never saw any actual "how-to" write ups on performing this change.

As I've tried to do with all of my mods, both on the SHO, and on my previous Charger build, I will a...
July 05, 2013, 11:05:45 AM by bpd1151
Views: 18873 | Comments: 3

The following step-by-step "How-To" details the measurements I came up with to re-position the TAURUS trunk badge lettering.

I opted to perform this mod because I thought that the final outcome was more much complimentary to the SHO's overly large rear end.

You should compile the following tools to assist you in completing this project:

1 Grease "Stabilo" Type Pencil
1 X-acto knife / razor
1 Measuring Tape
1 Roll of Blue Pa
July 05, 2013, 11:24:57 AM by bpd1151
Views: 10754 | Comments: 0

**** Below is a "How-To" Tutorial on removing the old, 2010-2012 style side fender badging that has the verbiage 'TAURUS' molded into them, and instead, upgrading to the newer, 2013+ fender badging that has the 'SHO' verbiage.

This write up, as it appears below, was originally posted in another community, of which I am also a staff member of.

The user name for this creator is/was: "Unknown_Driver".

Therefore, thanks a
July 05, 2013, 10:38:15 AM by bpd1151
Views: 12627 | Comments: 4

Below are the steps I took to convert over my entire interior from the standard, factory installed incandescent type bulbs, over to LED's.

It is important to note, that this mod was performed on my 2010 SHO, and others have since found out, there are, or may be, variations in the lamp housing assemblies, depending on model year owned, and/or what option pkg's were ordered.

Although generally speaking, the procedures are very similar, if not the ...
Pages: 1 2 [3] 4 5 6
Welcome, Guest. Please login or register.
Did you miss your activation email?

* Top Topics

Back to top