February 16, 2020, 05:07:46 PM
collapse
collapse

Author Topic: 2013 XSport - DTC P0016 - Camshaft Position Correlation, Bank 1  (Read 5904 times)

Offline Macgyver

  • Elite Member
  • : Reading, Pa.......
  • Thank You
  • -Given: 77
  • -Received: 258
  • Posts: 638
  • Ecobooster
Re: 2013 XSport - DTC P0016 - Camshaft Position Correlation, Bank 1
« Reply #75 on: May 14, 2019, 07:34:08 PM »
timing tensioner?

I believe he was referring to the serpentine belt tensioner. Will confirm shortly when I pick up.

Iím a bit skeptical, but trying hard to give them the benefit of the doubt. Worst case, I bring it back tomorrow...


Sent from my iPhone using Tapatalk

So when did you get the ESP ? I was thinking about getting one soonish.

Offline MiWiAu

  • Elite Member
  • : Milwaukee
  • Thank You
  • -Given: 297
  • -Received: 400
  • Posts: 855
  • EcoBoobster
2013 XSport - DTC P0016 - Camshaft Position Correlation, Bank 1
« Reply #76 on: May 15, 2019, 04:14:49 AM »

So when did you get the ESP ? I was thinking about getting one soonish.

Just a couple months ago right after the timing chain failure before I rolled 75k miles.

I got mine through Ziegler Ford for over $1000 less than I was quoted by Ford ESP direct.

I opted for the 60k/48 mo plan, which was the most I could add with my current mileage. Thereís an inspection form that the dealer needs to complete, which ran me $125.

https://www.zeiglerfordesp.com/process/quickquote.aspx?type=primary



Sent from my iPhone using Tapatalk
« Last Edit: May 15, 2019, 04:23:09 AM by MiWiAu »
2013 XSport

Offline MiWiAu

  • Elite Member
  • : Milwaukee
  • Thank You
  • -Given: 297
  • -Received: 400
  • Posts: 855
  • EcoBoobster
Re: 2013 XSport - DTC P0016 - Camshaft Position Correlation, Bank 1
« Reply #77 on: May 15, 2019, 05:19:09 AM »
timing tensioner?

I believe he was referring to the serpentine belt tensioner. Will confirm shortly when I pick up.

Iím a bit skeptical, but trying hard to give them the benefit of the doubt. Worst case, I bring it back tomorrow...


Sent from my iPhone using Tapatalk

Confirmed - they replaced the serpentine belt and tensioner.

My skepticism is waning. After several days of this rattle (consistently appearing 45-60 sec after a cold start), there was no noise this morning...

Repair order attached for posterity.




Sent from my iPhone using Tapatalk
2013 XSport

Online SHOdded

  • Administrator
  • Elite Member
  • : Beltsville, MD
  • Thank You
  • -Given: 12486
  • -Received: 4103
  • Posts: 15745
Re: 2013 XSport - DTC P0016 - Camshaft Position Correlation, Bank 1
« Reply #78 on: May 15, 2019, 06:37:45 AM »
Would be great if this is true, fingers crossed :)  First instance of rattling caused by belt tensioner.  Usually it's like cards in bicycle spokes kind of "flitting" sound, mostly on colder days/near freezing & below.
2007 Ford Edge SEL, Powerstop F/R Brake Kit, TXT LED 6000K Lo & Hi Beams, W16W LED Reverse Bulbs, 3BSpec 2.5w Map Lights, 5W Cree rear dome lights, 5W Cree cargo light, DTBL LED Taillights

If tuned:  Take note of the strategy code as you return to stock (including 3 bar MAP to 2 bar MAP) -> take car in & get it serviced -> check strategy code when you get car back -> have tuner update your tune if the strategy code has changed -> reload tune -> ENJOY!

Offline MiWiAu

  • Elite Member
  • : Milwaukee
  • Thank You
  • -Given: 297
  • -Received: 400
  • Posts: 855
  • EcoBoobster
Re: 2013 XSport - DTC P0016 - Camshaft Position Correlation, Bank 1
« Reply #79 on: May 15, 2019, 06:57:54 AM »
Would be great if this is true, fingers crossed :)  First instance of rattling caused by belt tensioner.  Usually it's like cards in bicycle spokes kind of "flitting" sound, mostly on colder days/near freezing & below.

Yeah, I definitely would have guessed chain slap. Didnít sound like any tensioner/belt issue Iíve heard.

The little nugget in the repair order is to remove the accessory belt and see if the noise goes away. I could have done that, but I was convinced it was timing chain related.

Iíll check back if the noise returns. :)


Sent from my iPhone using Tapatalk
2013 XSport

Offline MiWiAu

  • Elite Member
  • : Milwaukee
  • Thank You
  • -Given: 297
  • -Received: 400
  • Posts: 855
  • EcoBoobster
Re: 2013 XSport - DTC P0016 - Camshaft Position Correlation, Bank 1
« Reply #80 on: September 10, 2019, 07:55:15 AM »
FYI, my coworker told me this morning that he got a P0016 code on his 2014 XSport with 73k miles. He bought it new and it's all stock.
2013 XSport

Online SHOdded

  • Administrator
  • Elite Member
  • : Beltsville, MD
  • Thank You
  • -Given: 12486
  • -Received: 4103
  • Posts: 15745
Re: 2013 XSport - DTC P0016 - Camshaft Position Correlation, Bank 1
« Reply #81 on: September 10, 2019, 08:04:20 AM »
Sorry to hear :(  Best I can say is coolant needed to be changed or maybe shoulda been running full synth all along.  Doesn't seem to be a place to point the finger tho.
2007 Ford Edge SEL, Powerstop F/R Brake Kit, TXT LED 6000K Lo & Hi Beams, W16W LED Reverse Bulbs, 3BSpec 2.5w Map Lights, 5W Cree rear dome lights, 5W Cree cargo light, DTBL LED Taillights

If tuned:  Take note of the strategy code as you return to stock (including 3 bar MAP to 2 bar MAP) -> take car in & get it serviced -> check strategy code when you get car back -> have tuner update your tune if the strategy code has changed -> reload tune -> ENJOY!

Offline MiWiAu

  • Elite Member
  • : Milwaukee
  • Thank You
  • -Given: 297
  • -Received: 400
  • Posts: 855
  • EcoBoobster
Re: 2013 XSport - DTC P0016 - Camshaft Position Correlation, Bank 1
« Reply #82 on: September 10, 2019, 08:41:55 AM »
Sorry to hear :(  Best I can say is coolant needed to be changed or maybe shoulda been running full synth all along.  Doesn't seem to be a place to point the finger tho.

Yeah, I donít have any details on his service history, but I found it curious that heís experiencing similar symptoms at nearly the same mileage that I had.

If he has it diagnosed/repaired, Iíll update with any new info. :)


Sent from my iPhone using Tapatalk
2013 XSport

 

* Featured Topics

* Recent Topics

Re: Misfiring codes P0300, P0302 and P0306
by SHOdded | Today at 05:06:48 PM
Whoa!  Running leaded fuel or fuel with MTBE in it?...
Re: Donít see much on here about ***. Looking at them, Gearhead, and AJP
by Ls2bait | Today at 04:37:04 PM
I already have an AFE with the lid I picked up after I bought it so Ií...
Re: Rear window leak?
by TopherSho | Today at 02:37:46 PM
Yeah this is the rear REAR glass, back passenger was up for sure as I ...
Re: Roof channel trim
by TopherSho | Today at 02:22:16 PM
Ty both!.. hard to replace myself?  ...
Re: SHO whining noise?
by ZSHO | Today at 10:49:25 AM
It could be your Torque converter! How many miles on your SHO! Did you...
Re: SuperPete SHO Build record
by SuperPete | February 15, 2020, 03:15:01 PM
February updateSwitched to E40 fuel,Few revisions with MattDYNO number...
Re: Xtreme-Di HPFP35 on E40 GearHead tuned - MY REVIEW with VIDEOS
by SuperPete | February 15, 2020, 02:09:51 PM
So, to finalize this chapter, dyne is done, numbers posted and recorde...
DYNO numbers are in
by SuperPete | February 15, 2020, 02:06:52 PM
Another reason to go with GearHead...426/446All in the video belowhttp...
Re: Ford Recalls
by Leadfoot | February 15, 2020, 10:36:54 AM
FORD EXPLORER RECALL: SUSPENSION PROBLEMS IN 1.2 MILLION SUVS. Z ...
Counterfeit Ford Motorcraft Parts!
by ZSHO | February 14, 2020, 05:25:04 PM
Buyer Beware.. Don't Get Burned Buying Counterfeit Ford Motorcraf...
Re: Duel injection washing effect vs methanol-a real life look (Meth pictures wanted
by ZSHO | February 14, 2020, 03:02:17 PM
Great Topic indeed!  :)  I would @ the very least add an OCC...
Re: Post a Pic of your Ecoboost!
by SHOdded | February 14, 2020, 10:29:33 AM
Best of luck, man, hope all goes just perfect with the pregnancy &...
Re: 2013 - 2018 Flex, Taurus SHO and Interceptor & Lincoln MKT recall
by sm105k | February 14, 2020, 10:25:53 AM
Funny you say that, I am going to cut my H&R's this weekend.&...
Re: rouch brand
by SHOdded | February 14, 2020, 10:24:58 AM
You want a real intake?  Get one from ecopowerparts.com.  It...
Re: Wrapping intake pipe, numbers are out<<<
by SHOdded | February 14, 2020, 02:16:01 AM
What a joke!...

Back to top