November 29, 2021, 06:02:52 AM
collapse

Author Topic:  Replacement windshield washer reservoir cap branded for methanol???  (Read 3705 times)

Offline Gray Brick

  • Sr. Member
  • *
  • Southern California
  • Thank You
  • -Given: 34
  • -Received: 108
  • Posts: 432
  • Gray Brick
  • Liked:
  • Likes Given: 0
Does anyone make this? 
2013 Ecoboost Ford Flex
AJP Tune (ATP+2) in progress , Livernois HPFP, 3 Bar MAP, UPR Catch Can, 100% Methanol w/ braided steel lines, 3" Downpipes -->2.5" X-pipe --> 2.5" Magnaflow exhaust, 2.5" air inlets to each turbo with cone filter, Custom water to air intercooler with chiller
275/40-20 Front 315/35-20 Rear Tires
---12.419ET/112.43MPH @ 5150 lbs in the 1/4---

Offline J-Will

  • Elite Member
  • *
  • Thank You
  • -Given: 68
  • -Received: 106
  • Posts: 614
  • Ecobooster
  • Liked:
  • Likes Given: 0
Re: Replacement windshield washer reservoir cap branded for methanol???
« Reply #1 on: December 08, 2014, 02:28:26 PM »
I think this was asked before, and I dont know the outcome.  I would reach out to Billet Badget (vendor on this board) since they do CNC work, and the cap is not under any pressure or heat requirements.  I would think they could do this pretty easily, but I have never dealt with them. 
2014 Factory Order SHO (non pp) Deep Impact Blue
Gearhead Automotive Performance Tune
3-bar
SP-542 plugs w/ GH gap

 


SimplePortal 2.3.5 © 2008-2012, SimplePortal