September 25, 2021, 01:39:58 PM
collapse
collapse

Author Topic:  Boost / Vacuum Source  (Read 6055 times)

Offline Ecoboost_xsport

  • 2015 Ford Explorer Sport
  • Full Member
  • *
  • Orangevale, CA
  • Thank You
  • -Given: 85
  • -Received: 132
  • Posts: 162
  • Mad Scientist
    • For The Workshop
  • Liked:
  • Likes Given: 2
Boost / Vacuum Source
« on: July 29, 2021, 12:36:21 PM »
Those of you wondering where a decent place to tap into a boost/vacuum source, here's one way to skin that cat.
 
 Wanted to keep this particular write-up out of my build thread as it can pertain to a few different platforms and is more informational than anything specific about my build.
https://www.fortheworkshop.com/?p=3418

Offline Linemonkey

  • Full Member
  • *
  • Seminole, Tx
  • Thank You
  • -Given: 111
  • -Received: 38
  • Posts: 89
  • Ecobooster
  • Liked:
  • Likes Given: 0
Re: Boost / Vacuum Source
« Reply #1 on: August 10, 2021, 02:05:40 PM »
Thank you! Good info and pictures. I've been putting off installing my meth system for months because I was nervous about hacking into lines. I opened up the forum and this was the first thread. No more excuses

Sent from my SM-N960U using Tapatalk

2013 SHO PP Tuxedo Black
3 bar
160 T-STAT
Catless DPs
Tune by AJP

 

* Recent Topics

Re: Updating SYNC with new maps and new highway exit numbers
by Peetah75 | Today at 07:19:46 AM
Hi Ta2dResqr,  Just saw your reply.  You are correct, that ...
Re: Terrain Management System Fault - wrench light
by EcoHell | September 24, 2021, 08:17:28 PM
All I can do is laugh at my predicament on the low voltage issue menti...
Re: Intermittent stutter under load
by bubbarotondo21 | September 24, 2021, 08:10:42 PM
any codes?  please post at least one representative datalog for f...
Re: SHO low fuel pressure help
by ridered74 | September 24, 2021, 11:13:01 AM
Maybe the fuel pressure sensor that is under the intake manifold? I�...
Re: Is this the proper adapter?
by LMKS012 | September 23, 2021, 07:43:28 PM
Now, I *COULD* just get an extra master cylinder cap and cut a hole fo...
Re: HID preference
by Ta2dResqr | September 23, 2021, 03:21:43 PM
Hey, did you ever upgrade your HID's?I have a 2016 as well .... b...
Re: Speedometer stopped working/not shifting
by SHOdded | September 23, 2021, 02:58:00 PM
how many miles on your SHO?would check the connectors at the solenoid ...
Re: My new ST
by SHOdded | September 23, 2021, 02:41:14 PM
Congrats!...
Re: 2015 Fusion 2.0
by SHOdded | September 23, 2021, 02:40:39 PM
p0012 is more likely something to do with timing. whether it is VCT so...
Re: PTU going bad
by SHOdded | September 23, 2021, 02:31:01 PM
how goes it?removing the driveshaft is possible and safe.  it wil...

SimplePortal 2.3.5 © 2008-2012, SimplePortal