August 02, 2021, 04:32:16 AM
collapse
collapse

Author Topic:  Looking for affordable wheels  (Read 1848 times)

Offline Dannymack

  • RotM Winner
  • Full Member
  • *
  • Longmont, CO
  • Thank You
  • -Given: 47
  • -Received: 99
  • Posts: 88
  • Mile High Club
  • Liked:
  • Likes Given: 2
Re: Looking for affordable wheels
« Reply #15 on: June 09, 2021, 12:38:08 AM »
If you're doing spacers to make them flush the rear usually needs about 5mm more than the front in my experience.
2013 MKS EcoBoost Fully Loaded
AJP E40 Tuned
XDI-35
Godspeed Springs
EBC Yellow Brake Pads

Offline FoMoCoSHO

  • Super Moderator
  • Elite Member
  • *
  • Thank You
  • -Given: 707
  • -Received: 1157
  • Posts: 5122
  • The Tenth Man
  • Liked:
  • Likes Given: 2
Re: Looking for affordable wheels
« Reply #16 on: July 04, 2021, 02:33:15 PM »
They should be just about right. Front stock wheels need about 15-17mm less offset to be flush and this set will bring you out 14ish mm. Should look good.
Is this the same for 2010-12?




Offline Dannymack

  • RotM Winner
  • Full Member
  • *
  • Longmont, CO
  • Thank You
  • -Given: 47
  • -Received: 99
  • Posts: 88
  • Mile High Club
  • Liked:
  • Likes Given: 2
Re: Looking for affordable wheels
« Reply #17 on: July 04, 2021, 05:13:36 PM »
They should be just about right. Front stock wheels need about 15-17mm less offset to be flush and this set will bring you out 14ish mm. Should look good.
Is this the same for 2010-12?


This I'm not sure of. Haven't measured those out.
2013 MKS EcoBoost Fully Loaded
AJP E40 Tuned
XDI-35
Godspeed Springs
EBC Yellow Brake Pads

 

* Recent Topics

ecoboost_xsport Consolidated Build/Maintenance Thread
by Ecoboost_xsport | July 30, 2021, 08:24:58 PM
Even though I haven't been posting as frequently lately (YouTube ...
Re: 15 Interceptor Sedan Ecoboost with GHT Tune - Engine Coolant Overtemp
by SHOdded | July 30, 2021, 02:58:41 PM
on the 2.7, ford says to replace the ECT sensor and/or the knock senso...
Re: Random Pull/Torque Steer after new moog lower control arms.
by SHOdded | July 30, 2021, 02:54:07 PM
have an independent service shop verify your work with the LCAs. ...
Re: Any advice on how to improve 1/4 mile times?
by SHOdded | July 30, 2021, 02:49:20 PM
https://www.ecoboostperformanceforum.com/index.php/topic,1239.0.html...
Boost / Vacuum Source
by Ecoboost_xsport | July 29, 2021, 12:36:21 PM
Those of you wondering where a decent place to tap into a boost/vacuum...
Re: New from Minnesota...
by PDSHO | July 27, 2021, 04:15:43 PM
Greetings from Nebraska.Greg...
Re: Ol' Guy in New England........
by PDSHO | July 27, 2021, 04:13:04 PM
Greetings from Nebraska.Greg...
Re: Terrain Management System Fault - wrench light
by EcoHell | July 22, 2021, 09:21:04 PM
Yes and this was on a 2015 SHO. She sat 3 days if I recall. Fri Sat S...
Re: Part numbers needed for rocker panel retainers...
by 6500rpm | July 11, 2021, 05:41:29 PM
Results-...
FREE Goody Bag Swag for Your Car Show
by RockAuto | July 08, 2021, 04:08:40 PM
RockAuto would love to work with your upcoming car show, cruise-in, sw...

SimplePortal 2.3.5 © 2008-2012, SimplePortal