Thanks for the quick reply!
So the process I was doing at first was jacking up one side, removing the shock, setting it back down, adjust +/- for height, Jack car back up, reinstall shock, raised arm up 1/4 inch and then threaded shock until bolt holes lined up. Buttoned everything up and then sat car back down. Did the same for the other side. Everything looked good and then when I went to move the car it all relaxed, as expected, but back to the same height as before.
Prior to that the only thing that was different was everything was in, unbolted shock, and when height was set redo preload. But again, would go back to the same height.
So cliff notes, instead of jacking up each side individually I should work with the entire rear off the ground, give some time to relax, adjust, button up, and then place back on the deck, correct?
Sent from my iPhone using Tapatalk