December 16, 2019, 05:13:53 AM
collapse
collapse

Author Topic: PolskiMeth V2  (Read 4197 times)

Offline polskifacet

  • Elite Member
  • : Chicago
  • Thank You
  • -Given: 114
  • -Received: 275
  • Posts: 746
  • OCD Oils Changer
PolskiMeth V2
« on: August 14, 2019, 12:19:32 PM »
Hey guys,
Did a small revision of my meth setup. Changed to a Snow Performance nozzle and EcoPower noisemaker pipe with 1/8th meth bung.

Also Mix is:
Splash washer fluid + 48 oz denatured alcohol (per gal)

Tip:
My push connect fittings were leaking. Replaced the nylon hoses with new ones, no more leaks.
AEM Dryflo drop in. PP Transmission Cooler and thermostat. 160 tstat, 3 bar map, plugs, AJP 93 Tune, PP Shocks and Springs

Offline SHOdded

  • Administrator
  • Elite Member
  • : Beltsville, MD
  • Thank You
  • -Given: 12206
  • -Received: 4009
  • Posts: 15607
Re: PolskiMeth V2
« Reply #1 on: August 14, 2019, 12:48:25 PM »
All systems go then!
2007 Ford Edge SEL, Powerstop F/R Brake Kit, TXT LED 6000K Lo & Hi Beams, W16W LED Reverse Bulbs, 3BSpec 2.5w Map Lights, 5W Cree rear dome lights, 5W Cree cargo light, DTBL LED Taillights

If tuned:  Take note of the strategy code as you return to stock (including 3 bar MAP to 2 bar MAP) -> take car in & get it serviced -> check strategy code when you get car back -> have tuner update your tune if the strategy code has changed -> reload tune -> ENJOY!

Offline Gray Brick

  • Sr. Member
  • : Southern California
  • Thank You
  • -Given: 34
  • -Received: 108
  • Posts: 426
  • Gray Brick
Re: PolskiMeth V2
« Reply #2 on: August 14, 2019, 03:46:02 PM »
The push fittings will leak again.... switch to braided steel with -an fittings.

2013 Ecoboost Ford Flex
AJP Tune (ATP+2) in progress , Livernois HPFP, 3 Bar MAP, UPR Catch Can, 100% Methanol w/ braided steel lines, 3" Downpipes -->2.5" X-pipe --> 2.5" Magnaflow exhaust, 2.5" air inlets to each turbo with cone filter, Custom water to air intercooler with chiller
275/40-20 Front 315/35-20 Rear Tires
---12.419ET/112.43MPH @ 5150 lbs in the 1/4---

Offline polskifacet

  • Elite Member
  • : Chicago
  • Thank You
  • -Given: 114
  • -Received: 275
  • Posts: 746
  • OCD Oils Changer
Re: PolskiMeth V2
« Reply #3 on: August 14, 2019, 04:49:56 PM »
The push fittings will leak again.... switch to braided steel with -an fittings.

Were fine until i disturbed them. Snow pump has push connect fittings so no point in only switching some.
AEM Dryflo drop in. PP Transmission Cooler and thermostat. 160 tstat, 3 bar map, plugs, AJP 93 Tune, PP Shocks and Springs

Offline TopherSho

  • Elite Member
  • : Eugene Oregon
  • Thank You
  • -Given: 477
  • -Received: 310
  • Posts: 1429
  • 1st boosted rig!
Re: PolskiMeth V2
« Reply #4 on: August 14, 2019, 07:51:09 PM »
What elbow are you using... I'm on my 5th devil's own elbow.
2010 non-pp, 50k miles, 3-bar,  .30 plugs, 170-T-stat, SNOW-KIT STG1, AJP TURBO METH TUNE-REV3
 
Best of 12.61 no DA correction

Offline polskifacet

  • Elite Member
  • : Chicago
  • Thank You
  • -Given: 114
  • -Received: 275
  • Posts: 746
  • OCD Oils Changer
Re: PolskiMeth V2
« Reply #5 on: August 14, 2019, 07:56:51 PM »
What elbow are you using... I'm on my 5th devil's own elbow.
Ones from McMaster-Carr
AEM Dryflo drop in. PP Transmission Cooler and thermostat. 160 tstat, 3 bar map, plugs, AJP 93 Tune, PP Shocks and Springs

 

* Featured Topics

* Recent Topics

Re: 802SHO 2010 Build
by MrCRKLPOP | Today at 04:20:25 AM
Cleaned her up a little. man goals for my 11 nicely done...
Re: New Colorado MKS EB Owner
by SHOdded | Today at 01:49:44 AM
Welcome to the community!  Sounds very reasonable ... for now ......
Re: New member from northern Ohio
by SHOdded | Today at 01:47:02 AM
Welcome!  It might take a lot of TLC to patch this grievous deed ...
Re: bpd1151's 2010 SHO Rebuild Thread....
by bpd1151 | December 15, 2019, 05:04:12 PM
@J-Will......That's excellent to hear 1st hand experience with th...
Re: 2.0 control pack discontinued
by BEEFKING69 | December 14, 2019, 09:54:24 PM
Any updates on how this is holding out?...
Re: What have you done to your Ecoboosted vehicle today?
by StealBlueSho | December 14, 2019, 07:49:29 PM
Nice addition!Meaty shoes from what I can tell, and paint looks to be ...
Re: Random thoughts for the day
by StealBlueSho | December 14, 2019, 02:30:17 PM
I think you should have decals made, rather large at that, and promine...
Re: PTU - Another one bites the dust
by avidmotion | December 14, 2019, 12:52:45 PM
Wonder if my pigtail will work as well......
Re: Fords at Carlisle 2020
by Leadfoot | December 13, 2019, 08:12:41 AM
I normally go every year on Friday and Saturday but never put a car in...
Unleashed December Specials, SCT / HPTuners + New Payment Options & Trade in / T
by tmcphail | December 12, 2019, 09:00:20 AM
Unleashed December Specials, SCT / HPTuners + New Payment Options &...
MOVED: Intercooler - Stock SHO Intercooler from 2014 SHO
by ZSHO | December 12, 2019, 07:18:40 AM
This topic has been moved to Parts for Sale or Wanted.https://www.ecob...
Re: South of Pittsburgh PA - MKS Ecoboost
by Ninja1320 | December 11, 2019, 04:08:51 PM
Thanks for the welcome everyone! I'll try to share any MKS specif...
Re: New from Louisiana
by 802SHO | December 10, 2019, 05:45:34 PM
Welcome and sweet Fusion Sport!  ...
Re: Looking for a aftermarket BOV for 2013 Taurus SHO
by derfdog15 | December 10, 2019, 06:45:13 AM
EcoPowerParts hot pipes with the Tial is the way to go. Better hotpipe...
Re: Not holding power in 1st gear in the cold?
by TopherSho | December 09, 2019, 08:54:07 PM
After a bump in tune revision it is much better.. still testing. ...

Back to top