• Welcome to Ecoboost Performance Forum. Please log in or sign up.
collapse

injectors are done, pump, e85?

Started by FLEXXX, August 01, 2019, 11:16:19 AM

Previous topic - Next topic

FLEXXX

So I had an injector that failed, I will be replacing all 6 with new OE's

I am thinking about doing a 60+ pump also, if I do I can go e85

just curios what any of you have done and any input or advice learned

thanks!!
Motor, turbo's, exhaust, intake, nitrous, W/M blah blah blah

limited02

Quote from: FLEXXX on August 01, 2019, 11:16:19 AM
So I had an injector that failed, I will be replacing all 6 with new OE's

I am thinking about doing a 60+ pump also, if I do I can go e85

just curios what any of you have done and any input or advice learned

thanks!!
You're wanting to go full E85?  I believe the next limiting factor is the LPFP. 

FLEXXX

I wasn't planning on it as there are only 2 or 3 pumps in my area.

but the horses would be nice.

I would have to ad a second LPFP in tank

I was curios what route people have gone and what the results where.
Motor, turbo's, exhaust, intake, nitrous, W/M blah blah blah

Gray Brick

I am running out of fuel from my LPFP as well..

I have had no luck finding a higher volume pump.


What are the options for an upgrade for this?

What other vehicles use this same pump?
2013 Ecoboost Ford Flex
AJP Tune (ATP+2) in progress , Livernois HPFP, 3 Bar MAP, UPR Catch Can, 100% Methanol w/ braided steel lines, 3" Downpipes -->2.5" X-pipe --> 2.5" Magnaflow exhaust, 2.5" air inlets to each turbo with cone filter, Custom water to air intercooler with chiller
275/40-20 Front 315/35-20 Rear Tires
---12.419ET/112.43MPH @ 5150 lbs in the 1/4---

76fomoco

Can you just parallel the factory pump in there with two of them?
2013 PP AJP E30 160 TS, sp542 plugs, 3 bar, PPE catted DP's, GH IC, GH turbos, XDI-35, EPP hot and intake
Best 3-29-21  11.85 with 3000 DA
DA trap best 117.96
E30 = 492 whp, 536 wtq
E30+meth 498 whp, 539 wtq

Gray Brick

Seems like a lot of work when there has to be another pump that is in similar size and design with more volume.

We had many options in the Mustangs...
2013 Ecoboost Ford Flex
AJP Tune (ATP+2) in progress , Livernois HPFP, 3 Bar MAP, UPR Catch Can, 100% Methanol w/ braided steel lines, 3" Downpipes -->2.5" X-pipe --> 2.5" Magnaflow exhaust, 2.5" air inlets to each turbo with cone filter, Custom water to air intercooler with chiller
275/40-20 Front 315/35-20 Rear Tires
---12.419ET/112.43MPH @ 5150 lbs in the 1/4---